Injen Jeep Wrangler (JK) (07-18) V6 3.6L/3.8L SES Muffler Delete Kit

The Jeep Wrangler is an amazing vehicle that comes from the factory ready to tackle the world. That said, there are a few design flaws that limit the amazing ability the Wrangler has to offer. One of those flaws is the reduced approach and departure angle from the oversize stock muffler and low hanging exhaust tip. Injen has recognized this issue and has an affordable solution that allow you not only improve your approach and departure angles, but also improve performance and completely change the sound of your JK!, , SES5003MD is our newest muffler delete kit for the 2007-2018 Jeep Wrangler JK (3.6L & 3.8L) and is a fantastic solution for those that want to climb those steeper obstacles without breaking the bank on a high tuck exhaust. In fact, you can easily swap over to this muffler delete for the weekend wheeling trips and then reinstall your OE muffler for your weekly commute ? all within 20 minutes. This isn't our cheap delete kit made from thin cold-rolled steel that will either rust or crack, the Injen Muffler Delete kit is made for 304 stainless steel that is mandrel bent right here in Pomona, CA for durable, long-lasting performance. During the design process, our engineers made sure that the install was a simple as possible and retained the use of the factory hanger locations. This allows for quick swaps without throwing any wrenches!, , As always, the SES5003MD muffler delete works seamlessly with our full line of Jeep performance products. From Rotomolded air intakes to throttle response controllers to complete performance exhaust systems, Injen Technology is here to help you take on the world in your Jeep! Features and Benefits Made From Mandrel Bent 60mm 304 Stainless Steel Provides increased approach and departure angles Aggressive engine tone, especially under full throttle Injen's Muffler Delete Kit replaces the restrictive factory muffler and exhaust pipe. Smooth pipe routing eliminates restrictions and greatly improves airflow Uses Factory Hanger No additional tuning required Simple Bolt-on Installation using factory mounting points with no cutting or welding Injen Intake also available ? EVO5002 (3.8L) and EVO5003 (3.6L) Injen Snorkel also available - EVO15070 Injen X-Pedal Throttle Response Controller ? PT0013 Made in Pomona California, USA