Skunk2 Honda B16, B17, B18, K20 And K24 VTEC Applications - Pro Head Studs - B VTEC & K Series

Skunk2 Pro Series Head Studs for the B16, B17, B18, K20, and K24 VTEC (except K24Z7 Series) engines are manufactured from a premium grade 8740 chromoly steel that yields a tensile strength of 190,000 PSI!

Pro Series Head Studs are cold-forged for the best material strength, heat treated, and then thread rolled; increasing the stud and threads strength and fatigue resistance. Skunk2 Pro Series Head Studs also feature a straight pointed section at one end, that is reduced in diameter, just below the first threads that allow the studs to completely bottom out in the block and pre-load the fastener in the block. The hardware in these head stud kits include forged 12-point nuts and hardened parallel ground washers that even load distribution for accurate torque readings.

Features:

Universal Fit for B & K Series (except K24Z7 Series)

Hex Broached for Easy Install

Premium Grade 8740 Chromoly

Cold-Forged & Heat Treated

190,000 PSI Tensile Strength

Superior Rolled Threads

Black Oxide Coated for Corrosion Resistance

Dog-Point for Complete Seating & Pre-Loading

Does Not Fit the Non-VTEC B Series Engines Unless VTEC Head is Used

Fits
Honda B16A/B   
Honda B17A   
Honda B18C   
Honda K20   
Honda K20A   
Honda K20Z   
Honda K24   
Honda K24A   
Honda K24Z